How To Program Comcast Remote To Proscan Tv 'LINK'
Download https://urlca.com/2sXwqz
Note. Read the following steps before performing them.2. Press the cable button at the top of the remote. This will clear any button pushes from memory. If you mess up on any of the following steps, press the exit button followed by the cable button and start back at step 3. Press either the TV or AUX button (whichever one you are planning to program) once. it will blink red if you press it correctly.4. Press and hold the setup button until the TV or AUX button flashes twice.5. Enter the first 5 digit code you wrote down into the keypad. If you completed this correctly, the TV or AUX key will blink twice. If it does not, Go back to #2 above on this page.6. Now, test your remote by pressing the TV or AUX button (whichever one you programmed), and aiming it at your device. Then press the power button.7. If your device turns on and off as you press power on the remote, then you have successfully completed programming and should skip to step 5. If the remote does not operate the device, go back to #2 above on this page. OR of you have tried all the codes or you want to do this faster go to the next step.
Note. Read the following steps before performing them. Be sure to press the cable button to clear the remote. If you mess up any steps, press the exit button followed by the cable button and go back to #2.1. Turn on your TV or other device by pressing its power button.2. On your remote, press the TV or AUX button (the one you want to program) once.3. Press and hold the setup button until the TV or AUX button blinks twice4. Type 991 into the keypad, NOT 911. Then press either 0 for another cable box, 1 for a TV, 2 for a DVD, VCR, or PVR, or 3 for any audio device.5. Press the power button and then aim the remote at your device.6. Press the channel up button until the device turns off. Stop pressing immediately when the device turns off.7. Press the setup button to lock in the IR code. The TV or AUX button will blink twice.8. Check that you did this correctly by turning your device on and off with the remote. If it works, continue. If it does not, go back to #2
Congratulations! You have successfully programmed your Comcast remote to control your devices!Here are a few reminders that may be helpful.--Pressing one of the mode buttons on the top of the remote will set the remote to control that device--Pressing the all on button will turn on the cable box, followed by the TV, followed by the AUX device--When in cable mode, the volume buttons will control the TV volumeThank you. please post some comments on how this works for you.
I have a Sanyo DVD player along with an Xfinity/Comcast DVR. One tried the Sanyo codes that came in the programming pamphlet from Comcast and none of them worked. I tried the codes on this site and they didn't work either. As a matter of fact i tried codes from multiple website and not a single code worked. I've programmed the remote for different TV's, other DVD players and even VHS VCR's and have never had any of then not work with atleast one of the codes. I'm at a loss now and am stuck as to what to do now. Any suggestions? 2b1af7f3a8